Type 2 FK Bay Window Big Rear Chassis Notch Set
$475.00
This Bay window big rear chassis notch set is the ideal solution providing the clearance for your IRS arms and axles if you are wanting to sit the stance of your kombi lower than 6 inches in the rear.
Consisting of two cold forged then fully welded box section chassis notches with added upper shock mount brackets this kit will provide the travel clearance needed.
We have designed these notches to make the install much easier by allowing the notch sections to be slipped up inside the original rails once the old chassis is cut and prepared
Take the guess work out of designing your own notches and install one that follows the factory body work lines.
Detailed fitting instructions are supplied with this kit.
Fresh Kustoms recommends that the installer has good knowledge of welding equivalent to -
Certificate III in Engineering - Fabrication Trade
Some modifications require engineering approval, please check the requirements in your State or Territory
Quantity:
This Bay window big rear chassis notch set is the ideal solution providing the clearance for your IRS arms and axles if you are wanting to sit the stance of your kombi lower than 6 inches in the rear.
Consisting of two cold forged then fully welded box section chassis notches with added upper shock mount brackets this kit will provide the travel clearance needed.
We have designed these notches to make the install much easier by allowing the notch sections to be slipped up inside the original rails once the old chassis is cut and prepared
Take the guess work out of designing your own notches and install one that follows the factory body work lines.
Detailed fitting instructions are supplied with this kit.
Fresh Kustoms recommends that the installer has good knowledge of welding equivalent to -
Certificate III in Engineering - Fabrication Trade
Some modifications require engineering approval, please check the requirements in your State or Territory
This Bay window big rear chassis notch set is the ideal solution providing the clearance for your IRS arms and axles if you are wanting to sit the stance of your kombi lower than 6 inches in the rear.
Consisting of two cold forged then fully welded box section chassis notches with added upper shock mount brackets this kit will provide the travel clearance needed.
We have designed these notches to make the install much easier by allowing the notch sections to be slipped up inside the original rails once the old chassis is cut and prepared
Take the guess work out of designing your own notches and install one that follows the factory body work lines.
Detailed fitting instructions are supplied with this kit.
Fresh Kustoms recommends that the installer has good knowledge of welding equivalent to -
Certificate III in Engineering - Fabrication Trade
Some modifications require engineering approval, please check the requirements in your State or Territory
